Configuring Low-Power Sleep Mode
Popoto has two low-power sleep modes:
- In POWERDOWN mode, nearly all board voltage supplies are shut down, resulting in very low-power sleep. It takes about 20 seconds to power up and exit POWERDOWN mode.
- In DEEPSLEEP mode, the processor is placed into hibernation while RAM remains powered and refreshed. This mode consumes more power than POWERDOWN, but wakes in less than 1 second.
Each mode can be entered through an API or pshell command. The pshell interface exposes the powerdown and deepsleep commands. Refer to the Popoto API reference for API access details.
Waking up a Modem
In either low-power mode, a dedicated wake-up processor monitors acoustic signals in the water for a wake-up signal. The wake-up signal is based on the standard modem message header acquisition pattern. To wake a modem, send any message into the water. The acquisition signal wakes the modem, although the transmitted message itself is lost.