Skip to main content

Connection Interfaces

Popoto Modems can connect to an external device through serial, Ethernet, USB adapter, or product-specific board-level interfaces. The interfaces available on a given unit depend on the product family and ordered configuration.

Ethernet overall provides more options of interfacing (pshell or WebUI or SSH), so if, for example, someone was integrating a modem into a AUV, and they wanted a single interface, they may opt to using ethernet only, even if their primary way of controlling the modem was through pshell. Ethernet also is more responsive and less prone to errors in the case there is electrical noise or faulty wiring in a system. In the cases of the S-series modems, some are sold with ethernet-only interfaces or serial-only.

Ethernet
Availability

Available on most enclosed modems, Deckbox systems, with the exception of S-Series modems configured for serial, and OEM modem configurations with Ethernet exposed through the product interface.

Gigabit Ethernet

The PMM5544 and PMM6081 support Gigabit Ethernet.

Pros

Ethernet provides the highest-speed and most flexible host connection for Popoto command sockets, host APIs, real-time PCM capture, and software updates. Also allows for Web UI access, remote API calls, and PCM streaming.

Cons

Ethernet typically adds approximately 200-300 mW of power consumption. Standard copper Ethernet cable length is also limited to approximately 100 meters.

Notes

Connect to the modem IP address using telnet on port 17001 for a pshell-style command session, or use SSH to connect to the Debian Linux terminal.

RS-422 4-Wire Serial
Availability

Available on most OEM and enclosed modem configurations. Some enclosed modems with more limited connectivity (e.g. the S-Series modems) are configured as either Ethernet or serial, so RS-422 is not available if Ethernet is chosen. Available via USB when using the Popoto Digital Interface board or Dockmate.

Pros

RS-422 is well suited for longer cable runs than RS-232 and provides a robust differential serial interface for command, status, and low-rate data communication.

Cons

The host side needs an RS-422 interface or adapter. The default serial rate is 115200 bps, which is suitable for command and status traffic but not for high-rate PCM streaming.

Notes

Configure the terminal for 115200 bps, 8 data bits, no parity, and 1 stop bit.

RS-232 Serial
Availability

Available on most OEM and enclosed modem configurations. Some enclosed modems with more limited connectivity (e.g. the S-Series modems) are configured as either Ethernet or serial, so RS-422 is not available if Ethernet is chosen. Available via USB when using the Popoto Digital Interface board or Dockmate.

Pros

RS-232 provides a simple full-duplex serial interface using transmit data, receive data, and ground.

This interface is useful for short local connections to host electronics or lab adapters.

Cons

RS-232 is intended for short cable runs. The default serial rate is 115200 bps, which is suitable for command and status traffic but not for high-rate PCM streaming.

TTL 3.3 V UART
Availability

Available on OEM modem interfaces where exposed. TTL UART is not exposed as a normal user host interface on enclosed modems.

Pros

The TTL 3.3 V UART is a board-level serial interface using transmit data, receive data, and ground at 3.3 V logic levels.

This interface is useful for short local connections to embedded host electronics.

Cons

TTL UART is intended for short, board-level connections only. It requires electrical compatibility with 3.3 V logic and is not appropriate for long cable runs. The default serial rate is 115200 bps, which is suitable for command and status traffic but not for high-rate PCM streaming.

Also see Choosing an Operation Mode.