Connection Interfaces
Popoto Modems can connect to an external device through serial, Ethernet, USB adapter, or product-specific board-level interfaces. The interfaces available on a given unit depend on the product family and ordered configuration.
Ethernet overall provides more options of interfacing (pshell or WebUI or SSH), so if, for example, someone was integrating a modem into a AUV, and they wanted a single interface, they may opt to using ethernet only, even if their primary way of controlling the modem was through pshell. Ethernet also is more responsive and less prone to errors in the case there is electrical noise or faulty wiring in a system. In the cases of the S-series modems, some are sold with ethernet-only interfaces or serial-only.
S-Series modems are designed to support either Ethernet or serial, but not both. Check your purchase documents to find out how your modem was configured before proceeding.
| Ethernet | |
|---|---|
| Availability | Available on most enclosed modems, Deckbox systems, with the exception of S-Series modems configured for serial, and OEM modem configurations with Ethernet exposed through the product interface. Gigabit Ethernet The PMM5544 and PMM6081 support Gigabit Ethernet. |
| Pros | Ethernet provides the highest-speed and most flexible host connection for Popoto command sockets, host APIs, real-time PCM capture, and software updates. Also allows for Web UI access, remote API calls, and PCM streaming. |
| Cons | Ethernet typically adds approximately 200-300 mW of power consumption. Standard copper Ethernet cable length is also limited to approximately 100 meters. |
| Notes | Connect to the modem IP address using telnet on port 17001 for a pshell-style command session, or use SSH to connect to the Debian Linux terminal. |
Refer to Interface Control for the exact connector, pinout, voltage level, and cable details for the selected Popoto Modem.
| RS-422 4-Wire Serial | |
|---|---|
| Availability | Available on most OEM and enclosed modem configurations. Some enclosed modems with more limited connectivity (e.g. the S-Series modems) are configured as either Ethernet or serial, so RS-422 is not available if Ethernet is chosen. Available via USB when using the Popoto Digital Interface board or Dockmate. |
| Pros | RS-422 is well suited for longer cable runs than RS-232 and provides a robust differential serial interface for command, status, and low-rate data communication. |
| Cons | The host side needs an RS-422 interface or adapter. The default serial rate is 115200 bps, which is suitable for command and status traffic but not for high-rate PCM streaming. |
| Notes | Configure the terminal for 115200 bps, 8 data bits, no parity, and 1 stop bit. |
| RS-232 Serial | |
|---|---|
| Availability | Available on most OEM and enclosed modem configurations. Some enclosed modems with more limited connectivity (e.g. the S-Series modems) are configured as either Ethernet or serial, so RS-422 is not available if Ethernet is chosen. Available via USB when using the Popoto Digital Interface board or Dockmate. |
| Pros | RS-232 provides a simple full-duplex serial interface using transmit data, receive data, and ground. This interface is useful for short local connections to host electronics or lab adapters. |
| Cons | RS-232 is intended for short cable runs. The default serial rate is 115200 bps, which is suitable for command and status traffic but not for high-rate PCM streaming. |
Also see Choosing an Operation Mode.