Skip to main content

Analog Board Expansion Interface

Overview​

The Analog Board Expansion Interface communicates with the modem MPU using +3.3 V logic-level digital peripherals. All pins are level-translated from the internal logic voltage to +3.3 V for robustness.

Electrical Connections​

All signal directions are relative to the OEM modem. Refer to the analog board connector locations figure for the connector's physical location.

PMM6081 analog board expansion interface schematic
Analog Board Expansion Interface schematic connections.
Analog Board Expansion Interface Electrical Pinout
Pin NumberI/OPin NameNotes
1P+3.3V+3.3 V out when unit is powered up
2II2S_RX_D1I2S receive data pin
3OSPI_SCLKSPI serial clock
4OSPI_CS_NSPI slave select
5ISPI_MISOSPI Master In Slave Out
6PGNDBoard ground
7I/OGPIO0_7General-purpose I/O
8I/OGPIO1_4General-purpose I/O
9I/OGPIO1_5General-purpose I/O
10I/OGPIO1_6General-purpose I/O
11I/OGPIO1_7General-purpose I/O
12PGNDBoard ground
Application support

Contact info@popotomodem.com if your application requires the Analog Board Expansion Interface.

Hardware Components​

The Analog Board Expansion Interface uses a Molex PicoBlade connector, P/N 0510211200, or equivalent. The recommended contacts are Molex P/N 0500798000, suitable for 26–28 AWG wire.

Molex PicoBlade twelve-position connectorMolex PicoBlade housing pin numbering
Analog Board Expansion Interface User-Side Molex Connector.
Analog Board Expansion Interface Components and Part Numbers
Part NumberManufacturerDescription
0510211200MolexPicoBlade 12-position connector receptacle, 1.25 mm pitch
0500798000MolexPicoBlade 26–28 AWG sockets
2002181900MolexPicoBlade hand crimp tool
2149202211MolexPre-crimped PicoBlade lead, 75 mm length

Mating Cable Notes​

Attach or detach the interface only while power is disconnected from the OEM modem to avoid electrical damage.