Skip to main content

Power Switch Interface

Overview​

The Power Switch Interface is a single connector that enables GPIO power-down control of the OEM modem.

Electrical Connections​

All signal directions are relative to the OEM modem. Refer to the top connector locations figure for the physical location of the connector.

PMM4511 power switch interface schematic
Power Switch schematic connections.
Power Switch Electrical Pinout
Pin NumberI/OPin NameNotes
1PVDD_3V3+3.3 V out when unit is powered up
2IPower SwitchShort to GND to power down the unit; leave open for normal operation
3PGNDBoard ground

Hardware Components​

The Power Switch Interface uses a Molex PicoBlade connector, P/N 0510210300, or equivalent.

Molex PicoBlade three-position connectorMolex PicoBlade housing pin numbering
Power Switch Interface user-side Molex connector.
Power Switch Interface Components and Part Numbers
Part NumberManufacturerDescription
0510210300MolexPicoBlade 3-position connector receptacle, 1.25 mm pitch
0500798000MolexPicoBlade 26–28 AWG sockets
2002181900MolexPicoBlade hand crimp tool
2149202211MolexPre-crimped PicoBlade lead, 75 mm length

Mating Cable Notes​

Attach or detach the interface only while power is disconnected from the OEM modem.