MPU Expansion Interface
Overview
The MPU Expansion Interface communicates with the modem MPU using +5 V logic-level SPI, I2C, and GPIO peripherals. All pins on this expansion header are level-translated from the internal logic voltage to +5 V for robustness.
Electrical Connections
All signal directions are relative to the OEM modem. Refer to the digital board connector locations figure for the connector's physical location.

| Pin Number | I/O | Pin Name | Notes |
|---|---|---|---|
1 | P | VSYS_5V | +5 V out when unit is powered up |
2 | O | ECSPI1_SCLK_5V | SPI serial clock |
3 | I | ECSPI1_MISO_5V | SPI Master In Slave Out |
4 | O | ECSPI1_MOSI_5V | SPI Master Out Slave In |
5 | O | ECSPI1_SS0_5V | SPI slave select |
6 | O | I2C3_SCL_5V | I2C clock, maximum 400 kHz |
7 | I/O | I2C3_SDA_5V | I2C data |
8 | O | EXP0_OUT_5V | General-purpose digital output |
9 | I | EXP1_IN_5V | General-purpose digital input |
10 | P | GND | Board ground |
11 | P | VDD_3V3 | +3.3 V out when unit is powered up |
12 | P | GND | Board ground |
Because of the internal 5 V level translators, the signal directions shown above are fixed and cannot be modified.
Hardware Components
The MPU Expansion Interface uses a Molex PicoBlade connector, P/N 0510211200, or equivalent. The recommended contacts are Molex P/N 0500798000, suitable for 26–28 AWG wire. They can be crimped with Molex hand tool 2002181900; pre-crimped leads may also be used.


| Part Number | Manufacturer | Description |
|---|---|---|
0510211200 | Molex | PicoBlade 12-position connector receptacle, 1.25 mm pitch |
0500798000 | Molex | PicoBlade 26–28 AWG sockets |
2002181900 | Molex | PicoBlade hand crimp tool |
2149202211 | Molex | Pre-crimped PicoBlade lead, 75 mm length |
Mating Cable Notes
Attach or detach the interface only while power is disconnected from the OEM modem to avoid electrical damage.