Skip to main content

RTC Coin Cell Interface

Overview​

The RTC Coin Cell Interface provides coin-cell backup power to the OEM modem's real-time clock, allowing calendar time to be retained across main-battery power cycles.

Electrical Connections​

All signal directions are relative to the OEM modem. Refer to the digital board connector locations figure for the connector's physical location.

PMM5544 RTC coin cell interface schematic
RTC Coin Cell Interface schematic connections.
RTC Coin Cell Interface Electrical Pinout
Pin NumberI/OPin NameNotes
1PRTC_VBATRTC battery backup voltage supply, 1.0–5.0 V, nominal 3.0 V
2PGNDBoard ground

Hardware Components​

The RTC Coin Cell Interface uses a Molex PicoBlade connector, P/N 0510210200, or equivalent. The recommended contacts are Molex P/N 0500798000, suitable for 26–28 AWG wire.

Molex PicoBlade two-position connectorMolex PicoBlade housing pin numbering
RTC Coin Cell Interface User-Side Molex Connector.
RTC Coin Cell Interface Components and Part Numbers
Part NumberManufacturerDescription
0510210200MolexPicoBlade 2-position connector receptacle, 1.25 mm pitch
0500798000MolexPicoBlade 26–28 AWG sockets
2002181900MolexPicoBlade hand crimp tool
2149202211MolexPre-crimped PicoBlade lead, 75 mm length