Skip to main content

CODEC Input/Output Interface

Overview​

The two CODEC Input/Output Interface connectors provide up to four analog inputs and four analog outputs in addition to the standard acoustic transducer interface.

Electrical Connections​

All signal directions are relative to the OEM modem. Refer to the digital board connector locations figure for the connectors' physical locations.

Each headphone line output is single-ended and AC-coupled through a 47 µF capacitor. The resulting high-pass cutoff is f3dB,HPF = 1 / (2π × 47 µF × RLOAD). Full-scale output voltage is 0.5 V RMS.

By default, CODEC inputs are single-ended: only CODECn_LIN1 and CODECn_RIN1 are used, while CODECn_LIN2 and CODECn_RIN2 are unused. Full-scale input voltage is 0.5 V RMS. Each input is AC-coupled through a 0.1 µF capacitor; depending on the software-selected CODEC input impedance, the high-pass cutoff can be 159.2 Hz, 79.6 Hz, or 39.8 Hz.

For the differential-input option, which increases full-scale input voltage to 1 V RMS, contact info@popotomodem.com. The maximum CODEC input and output sample rate is 192 ksps, supporting frequencies up to 96 kHz.

PMM5544 CODEC input and output interface schematic
CODEC Input/Output Interface schematic connections.
CODEC Input/Output Interface Connector Electrical Pinout
Pin NumberI/OPin NameNotes
1PVSYS_5V+5 V out when unit is powered up
2OCODECx_HPLHeadphone line output, left channel
3OCODECx_HPRHeadphone line output, right channel
4ICODECx_RIN2Analog line input 2, right channel
5ICODECx_LIN2Analog line input 2, left channel
6ICODECx_RIN1Analog line input 1, right channel
7ICODECx_LIN1Analog line input 1, left channel
8PGNDBoard ground

Hardware Components​

Each CODEC Input/Output Interface uses a Molex PicoBlade connector, P/N 0510210800, or equivalent. The recommended contacts are Molex P/N 0500798000, suitable for 26–28 AWG wire.

Molex PicoBlade eight-position connectorMolex PicoBlade housing pin numbering
CODEC Input/Output Interface User-Side Molex Connector.
CODEC Input/Output Interface Components and Part Numbers
Part NumberManufacturerDescription
0510210800MolexPicoBlade 8-position connector receptacle, 1.25 mm pitch
0500798000MolexPicoBlade 26–28 AWG sockets
2002181900MolexPicoBlade hand crimp tool
2149202211MolexPre-crimped PicoBlade lead, 75 mm length

Mating Cable Notes​

Attach or detach the interface only while power is disconnected from the OEM modem to avoid electrical damage.