Skip to main content

Analog Line Input Interface

Overview​

The Analog Line Input Interface accepts an analog signal into the receiver pathway. The transducer receiver is normally digitized at separate 43 dB and 12 dB gains; using analog line input disconnects the transducer from the 12 dB pathway.

Move the Analog Input Selection Jumper from pins 1/2 to pins 2/3 before using this interface.

Electrical Connections​

The interface is single-ended and AC-coupled through a 10 µF capacitor with a 10 kΩ input resistor, producing a 1.59 Hz high-pass cutoff and approximately 10 kΩ pass-band input impedance. Gain is −1 V/V with an intentional 123 kHz low-pass roll-off. The full-scale ADC input is 5.32 V peak-to-peak.

PMM6081 analog line input interface schematic
Analog Line Input Interface schematic connections.
Analog Line Input Interface Electrical Pinout
Pin NumberI/OPin NameNotes
1, SMA centerILINE_INAnalog line input
2–5, SMA shellPGNDBoard ground

Hardware Components​

The Analog Line Input Interface accepts any standard SMA cable. One example is TE Connectivity P/N CSE-SGAM-305-SGAM.