Skip to main content

3-Pin Interface (Mid-2025 and Later)

The Transducer Interface attaches the acoustic communications transducer.

Connector revision

OEM modems manufactured from mid-2025 onward use a 3-pin terminal-block connector. For the older 6-pin version (models prior to mid-2025), refer to 6-Pin Interface (Mid-2025 and Earlier).

PMM6081 3-Pin Transducer Schematic​

All signal directions are relative to the OEM modem.

Refer to the analog board connector locations figure in the Interface Control Overview.

PMM6081 three-pin transducer interface schematic
3-Pin Transducer Interface schematic connections.

PMM6081 3-Pin Transducer Electrical Pinout​

3-Pin Transducer Interface Electrical Pinout
Pin NumberI/OPin NameNotes
1OTRANSDUCER_OUT_PTransducer output
2P/IGND/TRANSDUCER2Board ground or second transducer input
3PGNDBoard ground

Guidelines​

  • Connect the transducer between pins 1 and 3, with the shield, if present, connected to pin 2.
  • For a second receive-only transducer, contact info@popotomodem.com. By default, pin 2 is identical to pin 3 and connected to board ground.

PMM6081 3-Pin Transducer Hardware Components​

The 3-pin interface uses a Same Sky terminal-block plug, P/N TBP01P1-508-03BE, or equivalent. Its screw-cage clamps accept the transducer wires directly.

Same Sky three-position terminal-block plugThree-position terminal-block pin numbering
3-Pin Transducer Interface User-Side Connector.
3-Pin Transducer Interface Components and Part Numbers
Part NumberManufacturerDescription
TBP01P1-508-03BESame Sky3-position terminal-block plug, 5.08 mm pitch